Broyhill Saga Restoration Pt.1


The Saga as I found it. In need of a refinish.

We now present the saga of the Broyhill Saga dresser restoration.  Broyhill is probably best known for their Brasilia line but their Saga collection was no slouch either.  Broyhill described Saga as “a fresh twist to the New_1_sagaScandinavian furniture story”.  As a matter of fact, the label’s three crowns represent the three kingdoms of Scandinavia:  Norway, Swed
en and Denmark.
How’s that for useless trivia? Impress your friends with that little tidbit at this year’s holiday party. You can thank me later.


Doors with painted vertical stripes.

The finish on this piece needs some attention.  The worst areas are the top and the drawer fronts.  The finish on the doors is in pretty good shape.  The doors have vertical stripes that are painted on so I’m hoping I won’t have to strip them since that would remove the stripes.  I’ll do my best to match the new finish to the original finish on the doors.


The first order of business was to strip the old finish off.  I used my usual process of Citristrip followed by a wipe down with fine steel wool and mineral spirits.  The finish on this one was pretty thin so it came off without too much trouble.

Saga after stripping. Note the lighter contrasting wood on the legs.

Stay tuned for the next exciting installment of the saga of the Broyhill Saga!







Dresser In Need Pt. 3 / It’s Alive!!!

low2  New_1_New_1_res5

When we last left the Dresser In Need it was receiving some much needed veneer repair.  Much progress was made since then and it’s finally complete.  Joints were glued, wood was stained, shelf paper was removed and legs were fastened.

Let’s take a look….

low6After stripping the old finish we were left with this pale shell of its former self.

low5But after a little stain it’s coming back to life. I used Varathane American Walnut stain on this one.

bottom2bottom1Here we can see where the side panel was separating from the frame. Some new glue and a plethora of clamps and it’s back together again.

legsNext up was the legs. I’ve got a pretty sizeable stash of vintage pencil legs and attachment plates that I keep for just such an occasion. I found a set that were in great shape and just needed a few inches trimmed off and a fresh finish applied.  Now it’s ready to stand on its own four feet.

shelfI saved the best part for last – shelf paper removal. This is never a fun job. I usually attack it with a heat gun and a razor blade. If there’s any glue residue left it usually comes off with a scrubbing of mineral spirits.


The finishing touch was a fresh coat of satin lacquer and voila!  Not bad considering what we started with.

Thanks for following along and stay tuned for more furniture refinishing fun!

Dresser In Need Pt.2 / Veneer Repair Is Fun

Today’s order of business involves repairing damaged veneer on the dresser in need.  For this particular repair I cut a new piece of veneer just slightly bigger than the damaged area, placed the new piece over the damaged area and traced around it with a razor blade, removed the excess material and glued in the new veneer. I find this method sometimes works better than trying to cut the new piece to match the shape of the damaged area.

Here’s the damaged area with the new piece next to it.


Here I’m scoring the line that I traced around the patch. Hmmm, somebody needs a manicure.
Once sufficiently scored I’ll remove the excess material and the new piece will drop right in.


And there we have it. The new piece is glued in. I’ll place a clamp on it and go do my nails while it dries.


Stay tuned for more exciting updates on the Dresser In Need. Ooooh, can you stand the suspense?!?!

A Dresser In Need

It doesn’t look like much does it?



Judging by the stickers and doodles scratched into the wood, I’m assuming this dresser spent some time in a child’s bedroom.  I wasn’t sure if it was worth saving until I took a closer look. Underneath the stickers, stains and scars is some very attractive grain. Also, it’s a nice smaller size which always a plus when it comes time to sell it. I’ve found that most people just don’t have the room or the need for large pieces.

If it looks a little short that’s because somewhere along the line it lost its legs.  I’ll fashion a new set and it will stand tall and proud once again.

Here it is after stripping off the finish with a good dose of Citristrip.



Those are some mean looking scratches across the grain on the top. I won’t be able to completely erase those but hopefully they can at least be lightened a bit.

Stay tuned for more updates!